- 1 How do you keep yarn from slipping off the needle?
- 2 What is the best method of casting on knitting?
- 3 How many stitches should I cast on for a scarf?
- 4 What is long tail cast on method in knitting?
- 5 What is the point of a long tail cast on?
- 6 Can you change yarn in the middle of a row knitting?
- 7 How do you hide knitting mistakes?
- 8 Are metal or wooden knitting needles better?
- 9 Why is my cast on row so loose?
- 10 What is the advantage of casting on thumb method?
How do you keep yarn from slipping off the needle?
NEEDLE GUARDS are rubber tips to cover the points of the needles and to keep the yarn from falling off. TIP: Wind some rubber bands around the end of the needle. TIP: You can also just use a different colored yarn looped and tied over the needle which you slip onto the other needle as you work.
What is the best method of casting on knitting?
The long-tail cast -on method is probably the most popular among experienced knitters. It does take a bit of practice to get this method down, but once you understand what you’re doing it’s quick and easy to get stitches on the needle. Uses: The long-tail cast -on also counts as a row of knitting, which is nice.
How many stitches should I cast on for a scarf?
Cast on 12 stitches. This will give you a scarf that’s almost 5 inches wide, but you can alter the number of stitches for a wider or narrower scarf. There are a many different ways to cast -on. Try the long-tail cast -on or simple wrap cast on.
What is long tail cast on method in knitting?
Unlike the knit cast -on or cable cast -on, this one does not begin near the beginning of the ball of yarn. Instead, you have to start with a long tail, and the stitches are formed using both the tail and the yarn attached to the ball. The trick is to make sure that the tail is long enough for your project.
What is the point of a long tail cast on?
The long tail cast-on is one of the most common cast-on methods. This is because it’s extremely versatile. While it helps create an even edge (something that can sometimes be difficult to create with the single cast-on method), it’s also a great cast-on to use on projects in which you may want a fairly elastic edging.
Can you change yarn in the middle of a row knitting?
Starting a New Ball in the Middle When you see that you ‘re getting pretty close to the end of your first ball, pick up the yarn from the second ball. Then drop the old yarn and continue knitting with the new yarn. Once you ‘ve knit a couple of rows after the join, gently tug the work to even out the tension a bit.
How do you hide knitting mistakes?
First, stick a needle through the stitches immediately under the mistake so they don’t get loose. Do the same thing to the row on top. Next, thread some extra yarn–enough to go through three or four stitches on either side of the repair–into a yarn needle.
Are metal or wooden knitting needles better?
Metal needles are more durable than their wood or plastic counterpart and offer knitters faster speeds while knitting and the smoothest surfaces. Metal needles are particularly useful with yarns that tend to catch and can make knitting with them a smoother, less frustrating experience.
Why is my cast on row so loose?
If your cast -on stitches are too loose, you can try using needles a size or two smaller. But make sure you don’t overcompensate and make your stitches too tight. You can also try to space the stitches closer together on the needle as you cast on. Most cast ons start with a slipknot (right).
What is the advantage of casting on thumb method?
The advantages of the thumb cast on: It creates a stretchy cast on and therefore is suitable for garments that need give e.g. sock and mitt cuffs (a revelation for me as hinted at in the introduction above!) It is simple to do in the middle of your knitting as you continue to work in the same direction.