FAQ: Which Knitting Bind Of Method Matches The Long Tail Cast On?

What is the best way to cast on in knitting?

The long-tail cast -on method is probably the most popular among experienced knitters. It does take a bit of practice to get this method down, but once you understand what you’re doing it’s quick and easy to get stitches on the needle. Uses: The long-tail cast -on also counts as a row of knitting, which is nice.

What Do You Do With a Tail of long tail cast on?

Try to aim for having only a few inches of tail, but if it doesn’t work out that way, you can knit it with the other yarn for a few stitches then cut it. You can cut it to about 3 inches and leave it to weave in later. Just try to ignore it. Once you’ve knitted several rows, it won’t interfere with your knitting.

How long should a tail be for a long tail cast on?

If you need 20 stitches of 4mm diameter stitches, then you’ll need a minimum of 20 x 1.26cm length. Convert to inches (1” per 2.54cm) and you’ve got roughly 10” minimum for the tail to cast on. Add a few more inches so that you’ll have yarn to hold on to at the end; four to five inches should do it.

You might be interested:  Quick Answer: Which Is Easier Crocheting Or Knitting?

What is a sewn bind off?

This bind – off was developed by Elizabeth Zimmermann as a very stretchy alternative to the traditional bind – off. Its appearance is very similar to a standard long-tail cast -on edge, so it’s useful if you want your edges to match.

What is the best cast on for ribbing?

Best Cast Ons for Ribbing: Alternating Cable Cast On for 1×1 Rib

  • Leaving a tail for weaving in, tie a slip knot on needle.
  • Insert RH needle into first stitch on LH from front to back; yarn-over knitwise and pull through a loop; place loop on LH needle.

Leave a Comment

Your email address will not be published. Required fields are marked *